Nasiol PPFGuard New Formula is a next-generation nano-ceramic coating designed specifically for paint protection film (PPF). It boosts the film's performance, keeping it clean, slick, and crystal clear, while fully preserving its original properties, including self-healing and matte or satin finishes. Powerful UV and chemical resistance helps prevent yellowing and color fading so the film looks newer for longer, and its super-hydrophobic surface keeps dirt, contaminants, and water from clinging for faster, easier maintenance. PPF typically loses its hydrophobicity after about six months; PPFGuard restores and extends it for up to 2 years. Developed for professional detailers.
Nasiol PPFGuard 50mL
50mLGet notified when this item is back in stock
Press & drag to view
| Packaging | 50 mL |
| Appearance | Colorless liquid |
| Durability | Up to 2+ years |
| Consumption per unit area | 2–3 mL/m² |
| Water contact angle | 101–106° @10 µL |
| Water contact angle after 3000 wet scrub (ISO-11998:2006) | 95° @10 µL |
| Water sliding angle | 12–16° @20 µL |
| Chemical resistance | 12>pH>1 |
| Salt water resistance | Yes |
| Moisture resistance | Yes |
| Density @23°C | 0.845 g/cm³ |
| pH value | 7.5–8.5 |
| Dry to touch time | 4 h |
| Application temperature | 5°C–30°C (≤50% RH) |
Technical data from the Nasiol PPFGuard (New Formula) Application & Specifications sheet (Artekya Teknoloji Ltd. Şti.). Refer to the Safety Data Sheet before use.
For best results, apply as close as possible to 23°C and 50% relative humidity, in a shaded area, on a surface that is neither too cold nor too warm. PPFGuard is applied over paint protection film (PPF).
- Wash the vehicle thoroughly and gently. If the PPF surface is suitable, polishing treatments may be applied using silicone-free products. Dry the vehicle completely to prevent water drops during application.
- Remove any dust and dirt with Nasiol Clean and make sure the surface is thoroughly dry.
- Partition the application area visually or with masking tape. Do not work a partition larger than 1 m² at a time — overlapping partition edges do not cause problems.
- Shake gently before use. Remove the cap, place the small suede cloth on the block applicator, and apply the necessary amount of product onto the cloth. Recap the bottle to prevent air contact.
- Spread the product across the surface in horizontal and vertical movements. With the enclosed microfiber cloth, wipe any excess off within 30–45 seconds, avoiding swirls. A lighting system helps confirm no residue is left.
- During curing, keep the coated surface away from direct sunlight, excessive dust, water, and other contaminants. Do not wash with shampoo or detergents for the first 48 hours; the vehicle can go outdoors 24 hours after application.
Once cured, the coating is very difficult to remove from the film — removal is only possible by polishing or replacing the PPF of that section.